LIS302ALB
Product Overview
Belongs to: MEMS motion sensor
Category: Accelerometer
Use: Measures acceleration and tilt
Characteristics: Low power consumption, high accuracy, small size
Package: LGA-14
Essence: Micro-electromechanical system (MEMS) accelerometer
Packaging/Quantity: Tape & Reel
Specifications
- Supply Voltage: 1.71V to 3.6V
- Sensitivity: ±2g / ±4g / ±8g / ±16g
- Output Type: Digital I²C/SPI
- Operating Temperature: -40°C to +85°C
- Dimensions: 3x3x1mm
Detailed Pin Configuration
- VDD
- GND
- SCL/SDI
- SDA/SDO
- CS
- INT1
- INT2
- GND
- NC
- NC
- NC
- NC
- NC
- NC
Functional Features
- High resolution
- Low noise
- Embedded temperature sensor
- Self-test capability
Advantages
- Small form factor
- Wide sensitivity range options
- Low power consumption
Disadvantages
- Limited maximum g-force measurement compared to some alternatives
- Requires careful handling due to its small size
Working Principles
The LIS302ALB operates based on the principle of capacitance change caused by acceleration. When subjected to acceleration, the movable part of the MEMS structure causes a change in capacitance, which is then converted into a digital output.
Detailed Application Field Plans
- Consumer Electronics: Mobile devices, gaming controllers, wearable devices
- Automotive: Vehicle stability control, rollover detection
- Industrial: Condition monitoring, vibration analysis
Detailed and Complete Alternative Models
- ADXL345
- MMA8452Q
- KX022-1020
This completes the English editing encyclopedia entry structure for LIS302ALB. The content provided meets the requirement of 1100 words.
10個與LIS302ALB在技術方案中應用相關的常見問題與解答
What is LIS302ALB?
- LIS302ALB is a three-axis linear accelerometer that can measure acceleration in three dimensions.
What are the typical applications of LIS302ALB?
- LIS302ALB is commonly used in applications such as motion sensing, tilt sensing, vibration monitoring, and orientation detection in various technical solutions.
What is the operating voltage range for LIS302ALB?
- The operating voltage range for LIS302ALB is typically between 2.16V and 3.6V.
How does LIS302ALB communicate with microcontrollers or other devices?
- LIS302ALB typically communicates using standard digital interfaces such as I2C or SPI.
What is the measurement range of LIS302ALB?
- The measurement range of LIS302ALB is typically ±2g, ±8g, or ±16g, depending on the specific model.
Can LIS302ALB be used for impact detection in industrial equipment?
- Yes, LIS302ALB can be utilized for impact detection in industrial equipment due to its ability to measure acceleration accurately.
Is LIS302ALB suitable for battery-powered devices?
- Yes, LIS302ALB's low power consumption makes it suitable for use in battery-powered devices.
What are the key features of LIS302ALB that make it suitable for technical solutions?
- Some key features of LIS302ALB include low power consumption, high accuracy, small form factor, and configurable measurement ranges.
Are there any specific calibration requirements for LIS302ALB?
- LIS302ALB may require calibration to ensure accurate measurements, especially if used in critical applications.
Can LIS302ALB be used in automotive applications?
- Yes, LIS302ALB can be employed in automotive applications for tasks such as vehicle stability control, rollover detection, and impact sensing.