M25PE16-VMW6TG TR

Product Overview

Category

M25PE16-VMW6TG TR belongs to the category of Serial Flash Memories.

Use

This product is primarily used for storing and retrieving data in electronic devices such as microcontrollers, digital cameras, set-top boxes, and other consumer electronics.

Characteristics

• Non-volatile memory: The M25PE16-VMW6TG TR retains data even when power is disconnected.
• High storage capacity: This flash memory chip has a capacity of 16 megabits (2 megabytes).
• Fast data transfer: It supports high-speed serial communication protocols for efficient data transfer.
• Low power consumption: The M25PE16-VMW6TG TR is designed to minimize power consumption, making it suitable for battery-powered devices.
• Wide operating voltage range: It can operate within a voltage range of 1.65V to 3.6V.

Package and Quantity

The M25PE16-VMW6TG TR is available in a small form factor package, commonly known as an SOIC-8 (Small Outline Integrated Circuit). It is supplied in tape and reel packaging, with a quantity of 2500 units per reel.

Specifications

• Memory Capacity: 16 megabits (2 megabytes)
• Interface: Serial Peripheral Interface (SPI)
• Operating Voltage Range: 1.65V to 3.6V
• Maximum Clock Frequency: 75 MHz
• Erase/Program Time: 4 ms (typical)
• Data Retention: 20 years (minimum)

Detailed Pin Configuration

The M25PE16-VMW6TG TR has eight pins arranged as follows:

1. Chip Select (/CS): Used to enable or disable the device for communication.
2. Serial Clock (SCK): Provides the clock signal for synchronous communication.
3. Serial Data Input (SI): Used to input data into the device during programming or reading operations.
4. Serial Data Output (SO): Outputs data from the device during read operations.
5. Write Protect (/WP): When this pin is held low, it protects the memory from accidental writes.
6. Hold (/HOLD): Allows the device to be paused during a serial communication sequence.
7. Ground (GND): Connected to the ground reference of the system.
8. Power Supply (VCC): Connected to the power supply of the system.

Functional Features

• Sector Erase and Program: The M25PE16-VMW6TG TR supports sector-based erase and program operations, allowing efficient management of data.
• Protection Mechanisms: It provides hardware and software protection mechanisms to prevent unauthorized access or modification of stored data.
• Status Register: The device has a status register that provides information about the current operation and device status.
• Fast Read Mode: It supports a high-speed read mode, enabling quick access to stored data.

Advantages and Disadvantages

Advantages

• High storage capacity for its compact size.
• Low power consumption, making it suitable for battery-powered devices.
• Wide operating voltage range allows compatibility with various systems.
• Fast data transfer speeds for efficient communication.

Disadvantages

• Limited write endurance compared to other non-volatile memory technologies.
• Relatively higher cost per bit compared to some alternative memory solutions.

Working Principles

The M25PE16-VMW6TG TR utilizes the Serial Peripheral Interface (SPI) protocol for communication. It stores data in a series of memory cells that can be individually programmed or erased. The device uses a combination of floating gate transistors and control circuitry to store and retrieve data reliably.

Detailed Application Field Plans

The M25PE16-VMW6TG TR is widely used in various applications, including: - Microcontrollers and embedded systems - Digital cameras and imaging devices - Set-top boxes and digital televisions - Automotive electronics - Industrial control systems

Detailed and Complete Alternative Models

Some alternative models to the M25PE16-VMW6TG TR include: - M25P16-VMP6TG - M25PX16-VMP6TG - W25Q16JVSSIQ - AT25SF161-SHD-T

These models offer similar functionality and characteristics, providing options for different design requirements.

Word count: 511 words